Auto Lathe Helpers
Posted: Wed Aug 05, 2020 9:33 am
I often find myself cloning curves and rotating them around to turn a single curve lathe into a 3 or 4 curve lathe with a similar shape.
I've added an "Auto Lathe" helper that adds and positions these curves for you so you can go from turn a lathe into a 2,3 or 4 curve version with a click.
This is helpful for limbs where you can get a general shape with 1 curve, then convert it to 4 curves to refine the shape of each side without worrying about lining up cloned curves.
I've added an "Auto Lathe" helper that adds and positions these curves for you so you can go from turn a lathe into a 2,3 or 4 curve version with a click.
This is helpful for limbs where you can get a general shape with 1 curve, then convert it to 4 curves to refine the shape of each side without worrying about lining up cloned curves.