Until the new beta starts, I tried to see if I could figure out how to model in Truespace.
This is my first attempt and is unfinished. Still to add detail and then texture it.
The top one is the temp fish with sds applied and the lower one is the actual low poly model. (You can see the cage).
Mike R
While without Curvy meshes I tried... Updated X1
While without Curvy meshes I tried... Updated X1
Last edited by mykyl on Sat Feb 05, 2005 9:55 pm, edited 1 time in total.
Go to this page. These videos cleared up box modelling quick sharp for me. Just watching these videos just made it so clear. The principal works with other box modellers as well.
http://www.caligari.com/gamespace/tutorial/video.asp
I can now use My SIlo as well. Cool.
All I need now is the ability to import the base mesh into Curvy and add more detail. (Still quicker than standard ways.)
Mike R
http://www.caligari.com/gamespace/tutorial/video.asp
I can now use My SIlo as well. Cool.
All I need now is the ability to import the base mesh into Curvy and add more detail. (Still quicker than standard ways.)
Mike R
-
- Curvy3D Professional
- Posts: 795
- Joined: Mon Nov 24, 2003 8:34 pm
- Location: nc usa and http://artnutz.us/
-
- Curvy3D Professional
- Posts: 795
- Joined: Mon Nov 24, 2003 8:34 pm
- Location: nc usa and http://artnutz.us/
-
- Curvy3D Professional
- Posts: 795
- Joined: Mon Nov 24, 2003 8:34 pm
- Location: nc usa and http://artnutz.us/
-
- Curvy3D Professional
- Posts: 795
- Joined: Mon Nov 24, 2003 8:34 pm
- Location: nc usa and http://artnutz.us/