Page 1 of 1

object alignment

Posted: Tue May 08, 2018 7:13 am
by MrMajorThorburn
If I draw two wheel objects is the any way I can align them or can I draw a cylinder and then cut out the middle somehow?

Re: object alignment

Posted: Tue May 08, 2018 7:34 am
by Simon
In 3.0 the way I draw wheels (torus) is by drawing an almost closed C shape in a Lathe, then doing a mirror clone. The C and reflected C leave a hole in the middle. You need to turn off Cap Ends in object properties too.

If needed you can use Stitch Holes to close the loop.

Image

Re: object alignment

Posted: Tue May 08, 2018 1:00 pm
by MrMajorThorburn
Thank you.
Brilliant response.
Will enjoy trying that.