No 3D in my Viewports

Discuss Curvy 3D - Ask questions and share ideas.

No 3D in my Viewports

Postby bloodsong » Tue Aug 03, 2010 1:15 pm


yesterday i made a starfish in curvy3d. today i went to open my file, and there was nothing but a + in it! so i went to make a new mesh to test if things were saving properly, but when i draw a lathe, i only get lines and no 3d thingy!

any idea what might be causing that?

the 'only' thing i did was delete the curvy3d directory from 'my documents,' since i prefer to use the program directories instead. :X


oh... hahahah.... okay, i copied the curvy3d directory from where i want it to 'my documents' and now i see in 3d again.
Posts: 2
Joined: Tue Jun 15, 2010 2:20 pm

Postby Simon » Tue Aug 03, 2010 7:20 pm

I will add a warning message in new versions to check the default files have not moved, it can happen easily enough.
Posts: 2061
Joined: Wed Dec 01, 2004 8:13 am
Location: Kingston Upon Thames, U.K.

Return to General Discussion

Who is online

Users browsing this forum: No registered users and 3 guests