This is similar to the "Fit to" mesh commands from 3.0, but will only remove volume - and so acts like a cut operation.
Trim Curve
2 posts
• Page 1 of 1
Trim Curve
by Simon » Sun Feb 25, 2018 7:20 pm
Sometimes Booleans are overkill, and you just want to cut a shape down a bit. You can now Trim you model with a curve.
This is similar to the "Fit to" mesh commands from 3.0, but will only remove volume - and so acts like a cut operation.
This is similar to the "Fit to" mesh commands from 3.0, but will only remove volume - and so acts like a cut operation.
- Simon
- C.E.O.
- Posts: 1988
- Joined: Wed Dec 01, 2004 8:13 am
- Location: Kingston Upon Thames, U.K.
Re: Trim Curve
by Funken » Sun Feb 25, 2018 7:32 pm
This is actually amazing! Don't believe it, but I already wanted to propose a new "Cut Off" brush. This is a super method to produce hard surface objects.
-best wishes, Funken
-
Funken - Posts: 46
- Joined: Sat Feb 10, 2018 8:23 pm
2 posts
• Page 1 of 1
Return to Curvy 3D 4.0 Features
Who is online
Users browsing this forum: No registered users and 3 guests