Rough Cloth Scrap

Rough Cloth Scrap

Postby Simon » Tue May 21, 2013 11:18 pm

You can make a scrap of cloth out of a loft by using the Mask Brush to paint a rough line at the bottom (and holes) and then press delete to cut the faces.


For a more solid effect - Make a copy and move it slightly behind the original. Use "Mesh/Reverse Surface" to flip it (you can turn off Double Sides to check its real orientation). Then select both meshes "Mesh/Join" and "Mesh/Stitch Holes" to stitch the two parts together. The seam is left selected for easy smoothing (Press 'S').

For the little holes near the cord I again used Mask and Delete to make little holes in the mesh and used "Mesh/Stitch Holes" to seal the mesh back together.
Posts: 2057
Joined: Wed Dec 01, 2004 8:13 am
Location: Kingston Upon Thames, U.K.

Return to Tutorials

Who is online

Users browsing this forum: No registered users and 3 guests