Simon wrote:Hi Bunderfeld,
I expect you have found the Car Seat Tutorial?
This is an important feature to understand so I will have another go making a simple tutorial that runs through the process more clearly if you need one.
Simon wrote:Quite right - that one doesn't have audio. I will make a mini-tute focused on the export process ( with audio this time )
Simon wrote:I just sat down to make one - but couldn't log into 2nd life... so I am installing InWorldz to see how that works
I am going to demonstrate a teapot - the body, spout and handle have 1,2 and 3 curves respectively so it should be useful to you for making models.
Simon wrote:The teapot tuturial on TheBest3D ends by Merging the handle onto the body. Unfortunately that is one operation that will break the sculptie export (and end up with half a teapot).
How you solve this issue depends on how many prims you want to make the pot out of. For instance you could make the lid and body one prim, and the handle and spout another (with a hidden link between them inside the body).
I've just got my InWorldz account setup so I look forward to trying it out later
Simon wrote:Thanks for the welcome Bob
I logged into InWorldz today and a helpful greeter gave me some sandbox locations to work in. The upload and creating works just like SL so that was simple - but in InWorldz it is free to upload images and try stuff out
Simon wrote:In fact the only tricky point in the process is uploading the final video to youtube - apparently my 4 minute video will take over 5 hours to upload It will get there eventually... or I will try and upload it again tomorrow.
Simon wrote:I love Dropbox - I hadn't considered it for sharing large files on the internet.
Here you go 53Mb xvid avi:
Watch on YouTube Here
Users browsing this forum: No registered users and 1 guest